SilverStone PS06B Specifikace

PS06

Reinstall the front panel.Push the optical drive or 5.25” device into the 5.25” drive bay in all the way and PS06’s tool-less mechanism will lock it a

Insert a 3.5” or 2.5” hard drive as shown.Insérez un disque dur 3.5” ou 2.5” comme montré.依箭头所示方向推动，便可轻松的插入硬盘。Inserte un disco duro de 3,5” ó 2,5” com

Remove the hard drive tray from the drive cage.Remove hard drive tray’s locking clips.Извлеките фиксаторы из лотка для жесткого диска.Entfernen Sie di

Insert the hard drive into the tray and then secure it with the locking clips.Insert the hard drive tray back into the drive cage.Вставьте лоток для ж

Install all motherboard standoffs that are needed by the motherboard.Place the motherboard into the case over the standoffs and secure with screws.Пом

Loosen the expansion card’s tool-less mechanism.Remove the required expansion slot covers, the second to sixth covers are not reusable once removed.Сн

Install and secure required expansion cards.Installez et fixez les cartes d'extensions nécessaires.安装并锁固需要的扩充卡。Instale y fije las tarjetas de exp

Make sure all necessary cables and wires are connected, then reinstall the panels and secure with screws.Vérifiez bien que tout les câbles nécessaires

Please remove the fan filter as shown.Push the filter from one side of the front panel to pull out from the opposite side.Протолкните фильтр с одной с

Installation and system optimization guide:The following manual and guides were carefully prepared by the SilverStone engineering team to help you max

Issue date: Februsry, 2010NO: G11213630

PS06To push the thermal performance envelop of the Precision series to a new level, SilverStone engineers implemented the award-winning 180mm Air Pene

SpecificationsModel No.MaterialMotherboardDrive BayCooling SystemExpansion SlotFront I/O PortPower SupplyExpansion CardNet WeightDimensionSST-PS06B (B

SCREW APICTURE ITEMPACKAGE CONTENTUSB3.0 CONNETORHD AUDIO CONNETORPURPOSESECURE POWER SUPPLY AND MOTHERBOARDSECURE 5.25” DRIVE AND FLOPPYUSB 3.0 TO US

Unscrew screws from the side panel.Remove side panels from the case.Снимите боковые панели с корпуса.Entfernen Sie die seitlichen Blenden vom Gehäuse.

Unscrew screws from the PSU holder.Install PSU into the case as shown.Установите блок питания в корпус, как показано на рисунке.Installieren Sie das N

Adjust the PSU holder to fit the PSU.Secure power supply and PSU holder with screws.Ajustez le support pour bien fixer l'alimentation.Fixez l&apo

Remove the front panel as shown.Remove the 5.25” drive bay covers as shown.Снимите заглушки отсеков 5,25 дюйма, как показано на рисунке.Entfernen Sie